UniPunch
1-800-828-7061
Request a Quote Join Our Mailing List

Punch & Die Sharpener


Punch & Die Sharpener
 
Description
Cat. No.
Price
Sharpener Complete
with Grinding Wheel
1125
--
Grinding Wheel
1145
--
Diamond Wheel Dresser
1135
--
Spray Mist Attachment
1129
--
Punch & Die Gage - A Series
2068
--
Punch & Die Gage - B Series
3068
--
Safety Shield
1179
--
Grinding Wheel/Diamond Dresser
Spray Mist Attachment
Safety Shield
Punch & Die Gages
Refer to tool maintenance for additional sharpening information.



Punch and Die Sharpener is a bench type grinder. Simplicity of design and operation allows quick and easy sharpening of Flat Face Punches and Dies up to 2 5⁄8" (66.68 mm) diameter maximum.

For best results, the Sharpener should be bolted to a level worktable with the Swing Arm Punch and Die Holder handle extending beyond the edge of the table. The sharpener has a 1⁄2 H.P., 3450-RPM 115/208/230-volt 60 cycle motor. The Punch or Die is positioned in Swing Arm (A) and fastened securely in position with Knurled Head Screw (B). Adjustable Stop (C) is used for positioning of Punches and Dies in relation to grinding surface of the Wheel. Spring-loaded Ball Stop prevents binding as Punch or Die passes the gauge point. Laying straight edge across face of wheel sets the location of adjustable stop in relation to face of grinding wheel. The stop is adjusted out to it.

Holding Swing Arm Handle in right hand, swing up past the wheel while turning knurled feed dial (D) with left hand for precision control of feed. Each mark on the dial indicates .005" (.13 mm) feed. Adjust Back-up Stop (E) along bar to back up Punches and Dies. This Back-up Stop is also used to insure grinding Punches and Dies to the same lengths. Optional Spray Mist Attachment (Cat.No.1129) is available for mist cooling and lubricating Punches and Dies, and is equipped with a one-gallon tank, one nozzle, bracket, five-foot double tubing and operates from an air line pressure of 6 psi and up. Air inlet is 1⁄4" NPS(M). Grinding tolerance – 1"(25.4mm) diameter rod ground 90 degrees within .003: (.08mm).

Grease Fittings (F) are provided for periodic lubrication of Swing Arm. Totally enclosed self-lubricating motor will give years of trouble-free service. Sharpener should be regularly cleaned of grinding dust.

To dress grinding wheel, the Diamond Dresser, Cat. No. 1135, is secured in ‘V’ of Swing Arm and adjusted to the face of the wheel by means of the Knurled Feed Dial (D). Swing diamond across wheel at a steady, slow speed removing a few thousandths on each pass until properly dressed.

Print Catalog Page